Genesis Strato Decoupling Membrane extended informationInstallationBefore laying STRATO MEMBRANE, the substrate should be firm, sound, clean and be under the recommended moisture contentInserting Genesis STRATO MEMBRANE does not eliminate the need for expansion and perimeter joints, for which it is necessary to follow the instructions in the standard UNI 11493-1.Disconnecting Function01. Adhesive must be used to lay Genesis STRATO MEMBRANE over the substrate, using a notched trowel.02. STRATO MEMBRANE must be laid over the designated area, with the spunbonded cladded side facing down. STRATO MEMBRANE must then be pressed down into adhesive with the aid of a float, applying pressure to prevent the creation of air pockets. Genesis STRATO MEMBRANE must then be covered with another layer of class C2 (or greater) cementitious adhesive. The tiles can then be laid without waiting for it to dry, using a notched trowel of dimensions appropriate for the size of the tiles to be laid.Then proceed with point 7-8Waterproofing Function03. Other measures are required during the laying stage to provide the additional waterproofing function. After laying Genesis STRATO MEMBRANE, it is necessary to seal the joints between the adjacent sheets with adhesive, spreading it with the smooth side of the notched trowel.04. Then STRATO BAND must be applied.05. The same procedure must be followed for the perimeter waterproofing, then adhesive is applied.06. Then STRATO BAND must be laid. At the joint, STRATO BAND must overlap it by at least 50 mm. The same procedure must be used for the perimeter joints, using STRATO BAND centred in the floor / wall connection with adhesive.(For outdoor applications in particular, it is important to lay the cladding over the entire area, in compliance with the current reference standard 11493-1)07. Then the class C2 (or greater) cementitious adhesive must be spread followed by the laying of the finishing product08. The plinth/skirting board must be kept detached from the floor, the remaining gap must be sealed with elastic material (silicone or perimeter joint profile).Genesis STRATO MEMBRANE Physical ValuesPhysical ValuesStandardValueToleranceWeightDIN EN ISO 9864570 g/m2± 50 g/m2Thickness at 2 kPaDIN EN ISO 9863-13.25 mm± 1 mmTensile strength MD/CMDDIN EN ISO 103198/8 kN/m- 2 kN/mElongation at max load MD/CMDDIN EN ISO 1031933%-3 %Pull out (28 days, cement glue, room temp)DIN EN 13480.25 N/mm2± 0.15 N/ mm2Technical SpecificationsMat thickness: approx. 3 mmMaterial: Plastic HDPEWeight: approx. 570 g/m²Roll width: 1 mRoll length: 30 mAll information is approximate. Since we can not assume liability for special applications, a corresponding suitability test must always be carried out by the customer.SizesSTEM30 1 m width x 30 m lengthPacking UnitPieces = 1 roll, pallet = 6 rollsGenesi STRATO MEMBRANE Application & SubstratesSuitable for installation in damp and wet rooms, indoors and outdoors. Processing within 24 months from date of shipment.Concrete Screed (Anhydrite)Calcium Sulphate ScreedHeating ScreedPoured AsphaltConcreteResin and Coated FloorsChipboards and Pressed SheetsWooden FloorsSpecificationsQuick and easy installationMaximum protection for tilingIdeal for new build and renovation projectsProtects tiling against crackingHigh shear elasticityStorage and TransportThe STRATO MEMBRANE should be protected against external impact and abrasion during transportationGenesis STRATO MEMBRANE RecyclingSTRATO MEMBRANE can be disposed with PVC recyclingSTRATO MEMBRANE Technical Video Category: Underlays
