Everbuild Roll and Stroll Hard Surface Protection film – Bulk Buy and Pallet Deals

Everbuild Roll and Stroll Hard Surface Protection film extended informationApplication InstructionsEnsure surfaces to which EVERBUILD ROLL & STROLL Hard Surface Protector film is to be applied are clean sound, dust free and dry. Remove outer packaging from roll. Place roll on the floor facing the direction it is to be applied and unwind approx 12 inches (300mm) of material. Ensure the roll is stuck by smoothing out by either hand or foot. Simply push roll forward using hands or feet ensuring roll goes in a straight line.Smooth out with hands or feet as it unwinds. A very effective way of laying EVERBUILD ROLL & STROLL Hard Surface Protector film is to push the roll along with a soft broom/brush using the brush to smooth out and remove air bubbles as it unwinds. For application to worktops, glass etc roll and smooth out by hand until required length is reached. Carefully cut EVERBUILD ROLL & STROLL Hard Surface Protector with a sharp knife or scissors, take care not to damage or scratch the covered surface.This product is for application to hard surfaces, DO NOT use on carpets. Use Roll and Stroll Carpet Protector film.Adhesion will be reduced on dusty surfaces. Vacuuming or mopping prior to use is recommended.EVERBUILD ROLL & STROLL Hard Surface Protector film must be removed after a maximum of 4 weeks to prevent a sticky residue being left.Always check EVERBUILD ROLL & STROLL Hard Surface Protector is stuck firmly to surfaces before commencing work.On some surfaces EVERBUILD ROLL & STROLL Hard Surface Protector may leave a residue, this can be easily removed using Everbuild Wonder Wipes or hard surface cleaner. A test area is always recommended prior to full application. Please note when cleaning laminate flooring do not use excess water. Always check compatibility of cleaning agent with sub floor prior to full application.In heavily trafficked areas or where air temperature exceeds 22°C, remove EVERBUILD ROLL & STROLL Hard Surface Protector after 1 week maximum. Do not use underfloor heating whilst product is in situ.Do not use on surfaces which bleed oils or plasticizers.Product may become slippery when wet. Mop up any spills immediately or replace EVERBUILD ROLL & STROLL Hard Surface Protector where necessary.It is the users responsibility to determine suitability for use. If in doubt contact technical services for advice.Everbuild Roll and Stroll Hard Surface Protection film product informationPackaging600mm x 25m and 600mm x 75m rollsShelf Life36 months from date of manufactureStorage ConditionsStore in cool dry conditions between 5 and 25°C. Safe in normal use however as a precaution keep polythene outer packaging away from childrenThickness90 μm Categories: All Products, Building Supplies Pallet Deals